Monday, 3 February 2025

Setting up a VLAN on cisco packet tracer (student)

 What we did  

We first set up the network, adding 1 router, 1 switch and 4 clients. We then assigned the IP address, subnet mask, and the default gateway.  

 

On the switch, we must go to config and assign a VLAN, I started on the right giving it the number 20 and named it HR, the 20 matches the 3rd number on the default gateway. Then go into interface on config and press on the interface that matches the number above the switch. On the place where it says Access, press on it and change it to trunk. Then go onto the interfaces of the one that is on the right to start with. Change the VLAN to the one that is 20 and make sure that none of the other ones are on. 

 

Mistakes made 

  • Make sure that the interface that you are entering matches the number that is closest to the switch.  

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Making an ethernet cable

  Making ethernet cables   1. Cut the piece of cable that you need from what you have using the cable wire cutting tool   2. You then need t...

  • Making ventoy. T-level
      M aking a ventoy   This is how we made a ventoy . This is the video that we used to help us: https://www.youtube.com/watch?v=-7APoZzNPyU ...
  • Project planning for our VR tour project
      Smart objectives for VR project   S – Making a virtual tour of the IT department of the college .     M – Setting a time span for certain...
  • the roles of criminal laws
      The role of criminal law, industry standards and professional codes of conduct in digital context   If you breach the health and safety ac...